The overflow tube cannot work properly without the refill tube. Whenever the refill tube pushes down on the overflow tube, water is siphoned from the tank, causing the fill valve to cycle on and off. Get Fast, Free Shipping with Amazon Prime. Fix or replace the toilet float, overflow tube, and flapper. one piece toilet flush valve, universal toilet repair kit complete 2 inch toilet flapper/10 inch high toilet overflow tube. A toilet bowl doesn’t fill with water after flushing due to a float that’s too low, a faulty overflow tube or flapper, clogged toilet bowl jets, or a closed shutoff valve. The overflow tube is located below the refill tube. Too little water flowing to the toilet bowl won’t wash the wastes down the drain and can lead to clogs. If your float isn’t high enough it will signal to your toilet to keep filling and cause water to run into the overflow tube and constantly stay running. The job of the overflow tube is to empty the water directly into your toilet bowl. Your float should sit 1-2 inches below the fill valve and the overflow tube. Many toilets don’t have floats anymore, but if yours does you may need to adjust the height of your float. Toilet floats are made to make sure your toilet tank refills without overflowing.If it does not flush properly you may need to adjust the length of the chain again to make sure the flapper stays open long enough to let enough water into the bowl for a proper flush. Once the tank is full go ahead and give it a flush to test how well it flushes. Go ahead and turn the water back on and let the tank refill with water.You may need to adjust it several times to get it JUST right. You also don’t want to leave the chain too long or it will not be able to pull the flapper open all the way when you flush. The flapper is leaky and needs replacing. You don’t want the chain too short or it will constantly pull the flapper up and allow water to leak into the bowl. There are typically a few reasons why a toilet will keep running: The fill valve is worn out. Hold the chain up to see where it hits while the lever is at rest – leave about two links of slack in the chain.Attach the new flapper to the prongs on either side of the flush valve then hook the new chain up to the end of the toilet handle lever.Take the old flapper off by unhooking the chain from the lever/arm (connected to the toilet handle) and detaching it from the prongs on either side of the flush valve.If you’ve turned off the water to the toilet properly it will not refill with water. Give your toilet a flush to drain the tank of water.Head back over to your toilet and turn off the water to the toilet using the shut off valve near the base of the toilet. Before you do any work on your house it’s good to know where your emergency water shut off is just in case the toilet supply line or valve are leaking.For Kohler toilets, purchase a Kohler brand flapper.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |